Firmware Utility Software or the Cadex C5100 Battery Tester and/or its documentation. Part Number: 89-207-5050. Section 4: Upgrade the C5100 Firmware. Cisco 350, 350X, and 550X Series Switches Administration Guide Firmware Version 2.2.5.x. By the Virtual Cable Tester (VCT). VCT performs.

Ezfqjblg 15:49 I not abstain already in 1825 days. Hbpvdaws 13:34!! Cmrlcgoz 11:50 Mambo!!!

Amazon has been getting creepier and creepier lately with their recommendations. Every time I log in, I’m presented with a list of new Blinky LEDs, Raspberry Pi accessories, Arduino shields, and the like. It’s as if they know me. Their customer database paid off when it recommended a $22 transistor / component tester.

I’ve been seeing those testers around quite a bit lately. Eightball mjg discography rar. Curiosity got the better of me and my mouse found its way to the “Buy it now with one click” button. Two days later I had a “SainSmart Mega328 Transistor Tester Diode Triode Capacitance ESR Meter MOS/PNP/NPN L/C/R” in my hands.

I’m going to get the obvious out of the way. This thing is built cheap – as cheap as the factories can make it. My particular unit arrived with the LCD flapping in the breeze, hanging on by its flex cable. Fitting the LCD back into the acrylic backlight frame revealed a slightly worrisome twist in that same flex. Thankfully nothing was actually damaged, though I do want to give the flex cable some protection in the future. More on that later. The circuitry was open for all the world to see on the bottom of the tester. The heart of the unit is an ATmega328.

Supporting it are a few transistors and a handful of passives. I didn’t have huge expectations for the tester, but I hoped it would at least power up. Hooking up a 9 volt battery and pressing the magic button brought the tester to life. Since I didn’t have anything in the socket, it quickly lit up and displayed its maker information – “91make.taobao.com”, and “By Efan & HaoQixin”, then it informed me that I had “No, unknown, or damaged part”.

I had a few resistors lying around the bench (doesn’t everyone?) so I put one in. The tester read it as 9881 ohms. Sure enough, it was a 10K 5% resistor.

Capacitors – ceramic disc, electrolytic, and surface mount all worked as well. The tester even provided ESR values. The real test would be a transistor. I pulled an old 2N2222 in a TO-18 metal can, and popped it in the tester. The damn thing worked – it showed the schematic symbol for an NPN transistor with Collector, Base, and Emitter connected to Pins 1,2,and 3 respectively. Flipping the pins around and re-testing worked as well.

The tester showed hFe as 216, and forward voltage as 692 mV, both reasonable numbers for a 2N2222. The tester worked surprisingly well – it was able to correctly identify BJTs, FETs, even esoteric parts. The only thing it balked on was a linear voltage regulator, which showed up as two diodes.

Regulators are a bit more than a simple device though, so I can’t blame the tester there. The values returned were all reasonable as well.

While I don’t have a calibrated lab to check against, the numbers lined up with my Fluke meter. So what exactly is driving this little tester? There are about 20 versions of it on the market, all of them from China. Is a seller on taobao.com, often referred to as “China’s ebay.” 91make’s front page features no less than 7 versions of the transistor tester, with various cases and LCDs. Some digging turned up the history on this device.